Reply To: Variable stars

› Forums › Photometry › Variable stars › Reply To: Variable stars

#643750
Mr Ian David Sharp
Participant

Hi Connor,

I too am using my Seestar S50 Pro to do photometry but I’m not using the in-built feature because I want full control in the same way as I would with any telescope/camera setup. Also, as Jeremy says, there are unknowns in the in-built process at the moment.

I’m currently trying to work out a process that I’m happy with and I’m finding that the ASTAP software is the most useful at the moment. My process at the moment is:

In the Seestar (SS) app:
– Make sure you are storing RAW files in the SS app.
– Add the variable to my custom objects in the Seestar app.
– Set the exposure in the SS app depending on the brightness of the target to ensure no saturation (I’ve used 10, 20 and 30 seconds so far)
– Centre the SS on the target and autofocus. Then adjust the focus point up or down about 20 steps to defocus slightly
– The defocus step is important to prevent saturation and to smear the stars over enough pixels to help when we extract the green channel
– Now you can add the target to a Plan in the SS app and set it running

In the morning:
– Download the FIT files (you can ignore the jpeg files)
– Load the FIT files into ASTAP – extract the green channel (TG) and optionally average the files into groups (I use 3 or 4 – depending)
– Perform the photometry in ASTAP choose the comparison stars and and plot the results (I can’t explain all that here!)

There are videos out there on using ASTAP on Seestar data.

One important tip – After turning off Autofocus the SS app, make sure you also turn off autofocus on switching target in your plan. If you don’t do this, the SS will autofocus and lose your manual de-focus.

Lots more to say!

Cheers
Ian.