VISUAL SPEC and windowes 10 › Forums › Spectroscopy › VISUAL SPEC and windowes 10 This topic has 3 replies, 3 voices, and was last updated 7 years, 9 months ago by Peter Taylor. Viewing 4 posts - 1 through 4 (of 4 total) Author Posts 21 February 2017 at 12:11 am #573702 Peter TaylorParticipant Hi All, I cannot get visual spec 3.8.8 to run properly and cannot up grade to 4.2.6 in windows 10 is there a way to get it going. peter 21 February 2017 at 12:08 pm #577962 owen brazellParticipant I had the same issue but if you following th einstructions on the downlaod page under warning 5 and run as admin then it works. Owen 21 February 2017 at 12:41 pm #577963 Robin LeadbeaterParticipant Also some additional comments here which might be useful where a change to 256 colours was needed http://www.spectro-aras.com/forum/viewtopic.php?f=8&t=1660 Robin 21 February 2017 at 9:05 pm #577964 Peter TaylorParticipant Dune as you suggested, it is a bit better but has no colour on spectra lines, docent dived just puts a street line, any ideas or do I try and install it again. peter Author Posts Viewing 4 posts - 1 through 4 (of 4 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Connect with :Login with Sheep CRM Log In