Sam Jewell G4ddk VLNA for 1420 MHz Hydrogen Line Supply Voltage & Current

Forums Radio Astronomy Sam Jewell G4ddk VLNA for 1420 MHz Hydrogen Line Supply Voltage & Current

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #616912
    Sharon
    Participant

    Sam Jewell G4ddk VLNA I cannot find out what the Voltage/ Amperage should be to power the VLNA.
    I think it may be 12V but not sure on the supply Current

    #616928
    Roy Hughes
    Participant

    I did not have a clue what this post was about.
    So I googled G4ddk VLNA and came up with a .pdf which included the following.

    Quote:
    Voltage checks
    Connect +12 to +20V to the feedthrough capacitor C18 and the negative (ground) to the
    solder tag.
    Connect good quality 50Ω SMA terminations to the input and output connectors.
    Adjust R14 fully anti-clockwise and then turn clockwise about 30 degrees (not critical).
    Switch on the supply and check that the total current taken is approximately 80mA +/-
    10mA.
    :Unquote.

    It looks like +12v (or maybe +13v from a car batery) at 100mA to me!

    Have a look at the .pdf to see if it ties up with what you are doing:

    http://www.g4ddk.com/VLNASept13.pdf

    Hope the link works.

    Roy.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.