Forum Replies Created
-
AuthorPosts
-
Mr Jack Martin
ParticipantPeter and William,
Because the computer was displaying a black background, I could not see the text in the status bar.
So, in Personalisation settings change to a standard Microsoft picture.
All working.
Thanks for you help.
JackMr Jack Martin
ParticipantWilliam,
I have installed the Ascom platform.
Regards,
JackMr Jack Martin
ParticipantWilliam,
Thanks for the pointers I am installing on a ‘new’ Windows 10 system.
Regards,
JackMr Jack Martin
ParticipantPeter and William,
I should have explained I am installing Maxim on a new computer.
I followed your instructions but don’t see any numbers or i value?
Thanks for your inputs,
JackMr Jack Martin
ParticipantPeter,
Thanks for your input.
regards,
JackMr Jack Martin
ParticipantRobin,
‘I recall you have a remote adjustment, could this have been preloading it causing premature wear’?Are you advising against motorising the micrometer ?
Regards,
JackMr Jack Martin
ParticipantRobin,
I have released the collar. When tightened then slackened a fraction of a turn the micrometer is easier to turn.
It may be worth an overhaul as you suggest.
Thanks for your advices,
JackMr Jack Martin
ParticipantRobin,
It became increasingly tight over time.
From your photos and comparing with the other Lhires the collar looks engaged.
I will overhaul it as you suggest.
Question 1; What lubricant should be used and is there a risk of it getting on the grating?
The remote adjustment is the motorised collimating lens.
Regards,
JackMr Jack Martin
ParticipantRobin,
I loosened the grub screw but can’t turn the locking collar.
Regards,
JackMr Jack Martin
ParticipantRobin,
Thanks for the photos.
I will have another go at removing the grub screw.
I have another Lhires could swap micrometer shafts see if that works.
Regards,
JackMr Jack Martin
ParticipantRobin,
I can’t loosen the tiny crosshead grub screw which must be very tight.
Is there a particular type of screwdriver or extractor?
Regards,
JackMr Jack Martin
ParticipantDavid,
Thank you for answering my question.
Regards
JackMr Jack Martin
ParticipantMr Jack Martin
ParticipantPaul and William,
Issue 1 solved.
Issue 2 unsolved I will follow your instructions and report back.
THANKS FOR YOUR HELP,
JackMr Jack Martin
ParticipantThanks Paul.
Mr Jack Martin
ParticipantI am intrigued to know what the application is with two similar scopes like this on the same mount pointing at the same target.
Robin,
Just toying with the idea of doing high and low resolution Spectroscopy at the same time.
JackMr Jack Martin
ParticipantMartin and Grant,
Thanks for your advices.
It would be expensive and not really feasible.
If you don’t ask you don’t know!
JackMr Jack Martin
ParticipantThanks for clarification Peter.
Mr Jack Martin
ParticipantRobin and David,
I downloaded latest version guide will read to further understand how PHD2 works.
So far,so good.
JackMr Jack Martin
ParticipantRobin and David,
I have used the set up wizard in PHD2 to reconfigure the settings for my rig.
Just need a clear night to test the guiding, fingers crossed.
Jack -
AuthorPosts